steps
Category: Ticket Printer
Boca Printer Firmware – Which Version to Install
Best way to determine which firmware you’ll need is to print a self-test ticket and look at the firmware it currently has.
“G” version firmware may be downloaded to a printer that has “G” version or lower (F,E,D,C,B or A).
Download Version G“M” version firmware can only be downloaded to a printer that has “M” version already.
Download Version M“N” version firmware can only be downloaded to a printer that has “N” version already.\
Download Verison NTickets continuously feed out without cutting
- Please verify the slider bar has been properly adjusted to the ticket size being used each time the stock is changed and the sensors have been properly cleaned .
- If the above steps didn’t resolve the issue then default the printer settings. With the printer powered off hold down the TEST button and then power up the printer. Keep the TEST button held down for 10 seconds or until the motor moves a step then release it (the printer will reset at this time).
Boca – Cutter Failure
If you get an error message on your boca printer about a cutter failure, this will walk you through the few items needed to fix your printer.
Continue reading “Boca – Cutter Failure”
Boca – “BOOTLOADER 3” Error when powering it on
If your Boca give you the error of BOOTLOADER 3, this will article will help you fix that.
Continue reading “Boca – “BOOTLOADER 3” Error when powering it on”
Printer prints additional tickets
If the printer randomly prints additional tickets (blank) try this article to see if it helps resolve your issues.
Continue reading “Printer prints additional tickets”
How to disable the BIDI (Bidirectional) Printing
It is best to disable BIDI Printing for the fastest printing. Follow these easy steps to make the change on your system.
Continue reading “How to disable the BIDI (Bidirectional) Printing”
Installing the Ticket Printer Software
You have a ticket printer, now you need the software to make it speak with our website. Follow these easy steps to install our Ticket Printer software.
Continue reading “Installing the Ticket Printer Software”
Boca – Changing Default Settings / Factory Default
This should only be done by StubWire staff as it can cause your printer to no longer print.
Continue reading “Boca – Changing Default Settings / Factory Default”
Boca – Loading Image into Flash Memory
This should only be used by StubWire staff as it could stop your printer from printing.
Continue reading “Boca – Loading Image into Flash Memory”
How to load a Boca Ticket Printer
Installing the ticket stock into your Boca Ticket Printer
Continue reading “How to load a Boca Ticket Printer”
How to configure a Boca Ticket Printer
When you get a new Boca there are a couple items that should be set for the best output of the printer.
Continue reading “How to configure a Boca Ticket Printer”
Boca Ticket Printer – Erratic Cut Position
If your ticket printer is cutting the tickets in all different areas then check out this article.
Continue reading “Boca Ticket Printer – Erratic Cut Position”
Boca Ticket Printer – Cleaning the Thermal Print Head
The ticket printers need cleaned every now and then especially when you are having issues. Here is how you can clean the Thermal Print Head
Continue reading “Boca Ticket Printer – Cleaning the Thermal Print Head”
Boca Ticket Printer – Cleaning the Platen Roller
The ticket printers need cleaned every now and then especially when you are having issues. Here is how you can clean the Platen Roller
Continue reading “Boca Ticket Printer – Cleaning the Platen Roller”
Boca Ticket Printer – Barcode only half printed
Sometimes tickets will print where the barcode is half missing like the image to the right. This is a very simple fix.
Continue reading “Boca Ticket Printer – Barcode only half printed”